- Engine Oil Additives
- Fuel & Lubrication Equipment
- Fuel Additives
- Fuel Equipment
- Gear Lube
- Gear Oil
- HD Motor Oil
- Hydraulic Oil
- Industrial Oil
- Motor Oil
- Natural Gas Engine Oil
- Other Industrial
- PC ATF
- PC Motor Oil
- Torque & Transmission Fluid
- Transmission Fluid
- Turbine Oil
- Absorbent Dry Sweep Kitty Litter
- Absorbent Products
- Food Grade Products
- Synthetic Fluid Dispensing Equipment
RED-I GREASE EP 2 (35lb pail)
A PREMIUM-TACKY-ADHESIVE-MULTI-PURPOSE E.P. GREASE DESIGNED TO “STAY IN PLACE” IN THE MOST SEVERE WATER-WASHING AND SHOCK LOADING AUTOMOTIVE AND INDUSTRIAL APPLICATION.
RED- I Grease is a premium, heavy duty, EP Multi – purpose lithium grease fortified with polymers, anti-wear agents, tackiness additives, high viscosity base oils plus rust and oxidation inhibitors. This grease is designed to “stay-in-place and lubricate” under the most severe operating conditions found in industrial and automotive service. It is unsurpassed in resisting water wash out and protecting against wear in shock loading applications. Red-I Grease is the grease designed to “stay there and lubricate” under the worst conditions of water-dirt-mud.
Advantages & Uses
Recommended for wheel bearings, including disc brake applications, fifth wheel, u-joints, steering linkage, and chassis lubrication.
An ideal chassis lubricant for “on & off road” equipment in agriculture, construction, logging, trucking and mining service where severe water washing or shock loading protection is needed.
Also recommended for rock crushers, sand and gravel screens, oil field equipment, off-shore drilling equipment and marine deck equipment.
Recommended for industrial plain bearings and anti-friction bearings operating under shock-loads or wet and dirty conditions.
Not Recommended for Small Anti-Friction Bearings Operating over 5000 rpm.
Note: Tackiness additives used to make this grease “stay in place” and make this grease hard to pump and may require the use of a heavy follower plate and/or more powerful pump in air operated grease pumping systems.Not recommended for centralized dispensing system commonly found in industrial plants unless they are capable of pumping a grease of this type.
Adhesive-tacky grease that “stays in place and lubricates”.
Unexcelled water wash-out resistance due to high-viscosity base oils fortified with polymers.
Excellent protection against failures caused by shock loading.
Extreme pressure protection – Exceeds 70 pounds OK Load in the ASTM D-2509 Timken Test.
Critical metal surface of moving parts are protected from rust and corrosion.
Distinctive Red color quickly identifies the grease and helps detect defective bearing seals.
Reduced maintenance expense because “stay in place” attribute. Extends equipment life.
Oxidation inhibitors permit operations up to 150 ° C.(302 ° F) for extended periods
NLGI certified GC-LB in wheel bearing and chassis application.